Fusion Series

Radiant Poultry Brooder

Home  » Poultry Animal Infrared Heaters » Fusion Series

click to enlarge

Powerful And Fuel Efficient Radiant Heat
Space-Ray's new FUSION™ delivers a large, superior heat pattern at litter level. Better brood conditions mean more comfort for your birds.

Space-Ray Radiant Gas Tube Heaters operate using the same principle as the sun. Before heating the air, radiant warmth is delivered directly to the birds and litter area where it's needed most.

Features

  • An energy efficient radiant heating system that saves fuel, reduces maintenance & permits higher mounting..
  • Calorized aluminized steel emitter tubes* for corrosion resistance and greater radiant output.
  • Unique diagnostic monitoring lights show when heater is operating, and assists with fault diagnosis.
  • Ceiling stays cool – no need for insulated board above heater.**
  • Excellent radiant throw and even temperature distribution.
  • CSA design certified for safety.
  • 4" diameter tubes create a large radiant surface to emit more heat over a wide rectangular area.
  • Each unit comes with fresh air intake kit, exhaust hood, stainless steel flexible gas connector and a pre-wired electrical connection.
  • Features a 3-Year limited warranty on complete emitter assembly

TISSTM

Tube Integrity Safety Shut-Off System

U.S. Patent #8,000,075

Space-Ray’s patented innovative safety feature for positive pressure radiant tube heaters is called the “Tube Integrity Safety System'' (TISS™). The revolutionary TISS™ uses a simple principle to place an electrically insulated aluminum wire in tension above the reflector as shown above.
Low voltage is then continuously passed along the wire in line with the gas control circuit. If heat levels increase due to heat exchanger failure, the wire melts and the safety circuit is broken, breaking the 24 volt circuit and shutting down the heater.

  • Low profile mounting bracket permits easy leveling of brooder
  • Large deep dish canopy to efficiently reflect heat to litter area where it is needed most
  • The stainless emitter assembly is fully insulated and enclosed. It features a full 3-year limited warranty
  • The burner assembly with durable cast iron cap features large burner ports for more even heat distribution and years of trouble free service
  • The safety pan helps to shield litter area directly beneath the brooder
  • Has a stainless steel main burner gas line for strength and durability
  • The direct spark ignition model's 3-try direct spark ignition is in a moisture resistant enclosure for added reliability
Models Single Stage
BTU/HR (Kw) Input
Two Stage BTU/HR
High Input
Two Stage BTU/HR
Low Input
Total Emitter
Tube Length
FUS 60 60,000 (17.6 Kw) 60,000 (17.6 Kw) 40,000 (11.7 Kw) 15ft / 20ft
FUS 70 70,000 (20.5 Kw) 70,000 (20.5 Kw) 40,000 (13.2 Kw) 15ft / 20ft
FUS 80 80,000 (23.4 Kw) 80,000 (23.4 Kw) 55,000 (16.1 Kw) 20ft
Model Tube Length Total Length
FUS 60 20' / 6.1m 21'2" / 6.5m
FUS 70 20' / 6.1m 21'2" / 6.5m
FUS 80 20' / 6.1m 21'2" / 6.5m
Gas Type Control Option Burner Pressure Supply Pressure Voltage Amps Ignition Type
BTU/HR HIGH INPUT BTU/HR LOW INPUT Min Max
Natural N5 N7 3.5" W.C.8.7 mbar 5" W.C.12.5 mbar 14" W.C.34.9 mbar 120VAC60HZ 1.8 Direct Spark
Propane L5 L7 10" W.C.24.9 mbar 11" W.C.27.4 mbar 14" W.C.34.9 mbar 120VAC60HZ 1.8 Direct Spark

MINIMUM CLEARANCES TO COMBUSTIBLES

Model Side Ceiling* Below End
FUS 60 36"/ 91cm 12"/ 30cm 69"/ 175cm 32"/ 81cm
FUS 70 36"/ 91cm 12"/ 30cm 69"/ 175cm 32"/ 81cm
FUS 80 36"/ 91cm 12"/ 30cm 69"/ 175cm 32"/ 81cm
Power Inverter Kit (for battery back-up), Part #43619070

This provides temporary 120VAC to the brooder zone control (power supply) panel during power outages. The kit includes a batter trickle charger, changeover relay and power inverter to convert 12 volt DC into 120 volt AC.

 
Thermostat – Environmental (EW-4-20), Part #30525010

Ratings: SPDT 120/240VAC, 16A full load
Temperature range: -40° F to 104° F +/- 2.5° F differential
Housing: Watertight ABS plastic meets NEMA 4x and NEC Article 547-4 requirements for use in harsh environments.
Adjustable dial allows thermostat to be recalibrated.

Thermostat – Environmental (EW-4-20), Part #30525010
click to enlarge
Thermostat – Individual, Part #43317050 (for No. 5 Control only)

Temperature range: 58° F to 122° F with (10) temperature scale ranges. The thermostat is used to control individual brooders for Turkey heating applications. Includes Mears thermostat, plastic enclosure, bracket and screws to mount to Honeywell #VR8205 gas valve.

Thermostat – Individual, Part #43317050 (for No. 5 Control only)
click to enlarge
Hose Kit – No. 5 Controls:

1/4" ID x 6ft hose with 9/16-18 LH welding connector x 1/8 male pipe at one end and 1/4" male pipe opposite end, Part #30522290

Each kit includes:

Item No. Part Number Description Qty
1 30285000 Manual Ball Valve 1/2 Female Pipe 1
2 03338100 Bushing, 1/2 x 1/4 Galv. 1
3 30714020 LH Welding Connector 9/16-18 x 1/8 Male Pipe 1
4 03994050 Screen Mesh Gas Filter 1
5 30523290 Hose, 1/4" ID x 6ft with LH Welding Swivel x 1/4 Male Pipe 1
Hose Kits – No. 2 & No. 5 Controls:
click to enlarge
Manual Gas Shut-Off Ball Valve – ½” NPT, Part #30285000

The Deflector Kit (Part # 43504000) is used to reduce clearances to combustibles below the heater. It is designed to be used when the CB series is installed in a horizontal position.

Manual Gas Shut-Off Ball Valve – ½” NPT, Part #30285000
click to enlarge
Wire Brushes

Wire Brush – Long, Part #43295020

Wire Brush – Short, Part #43295010

Wire Brushes
click to enlarge